Formation Of Condensation; Handling Discs; Cleaning Discs - RCA 7L400MDV Mode D'emploi

Chapter 4: Other Information

Formation of Condensation

• Due to sharp changes in temperature and humidity, condensation may form if warm air comes in contact with any cold parts inside the
player.
• When condensation forms inside the player, it may not operate correctly. If this occurs, leave the player at room temperature until the inside
of the player becomes dry and operational.
• If condensation forms on a disc, wipe the disc with a soft, dry cloth by moving the cloth from the center of the hole toward the outer edge.

Handling Discs

• Don't touch the disc's signal surfaces. Hold by the edges or by one edge and the hole in the center.
• Don't affix labels or adhesive tape to label surfaces. Don't scratch or damage the label.
• Do not use damaged (cracked or warped) discs.

Cleaning Discs

• Dirty discs can cause reduced video and audio performance. Always keep discs clean by wiping them gently with a soft cloth from the inner
edge toward the outer perimeter.
• If a disc becomes very dirty, wet a soft cloth in water, wring it out well. Wipe the dirt away gently, and remove any water drops with a dry
cloth.
• Do not use record-cleaning sprays or anti-static agents on discs. Also, never clean the discs with benzene, thinner, or other volatile solvents
which may cause damage to the disc surface.
30 Chapter 4