Power Failure; Energy Saving Tips; Troubleshooting Guide - Avanti SAR14N1B-110 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Power Failure

Most power failures are corrected within a few hours and should not affect the temperature of your
appliance if you minimize the number of times the door is opened. If the power is going to be off for a
longer period of time, you need to take the proper steps to protect your food.
Moving Your Refrigerator
·
Remove all the food.
·
Securely tape down all loose items inside your unit.
·
Turn the leveling screws up to the base to avoid damage.
·
Tape the doors shut.
·
Be sure the unit stays in the upright position during transportation.

Energy Saving Tips

·
The unit should be located in the coolest area of the room, away from heat producing refrigerators
or heating ducts, and out of direct sunlight.
·
Let hot foods cool to room temperature before placing them in the unit. Overloading the unit forces
the unit to run longer. Foods that freeze too slowly may lose quality, or spoil.
·
Be sure to wrap foods properly, and wipe containers dry before placing them in the unit. This cuts
down on frost build-up inside the freezer.
·
Organize and label food to reduce door openings and extended searches. Remove as many items
as needed at one time, and close the door as soon as possible.
You can solve many common appliance problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling for service.
PROBLEM
Refrigerator does not operate.
Refrigerator does not cool.
Refrigerator is not cold
enough.
Vibrations.
The door will not close
properly.

TROUBLESHOOTING GUIDE

Not plugged in.
The circuit breaker tripped or blown fuse.
The refrigerator temperature control is set at "0"
The room temperature is hotter than normal.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The refrigerator does not have the correct clearances.
Abnormal voltage.
Check to assure that the refrigerator is level.
The refrigerator is not level.
The doors were reversed and not properly installed.
The gasket is dirty.
The shelves, bins, or baskets are out of position.
10
POSSIBLE CAUSE

Publicité

Table des Matières
loading

Table des Matières