Table des Matières
Publicité
DIGITAL TUNER
2. To prevent sound interference the bass control
options operate exclusively. You cannot combine
the bass from EQUALIZER with wOOx
4. GAMESOUND
To adjust the game sound, press GAMESOUND once
or more to select your option.
=Display briefly shows
or
Note: GAMESOUND is only available when you
play in GAME•AUX source.
How to MUTE the sound
1. Press MUTE on the remote control to interrupt
sound reproduction instantly.
= Playback continues without sound and the
display flashes
2. To reactivate sound reproduction you can:
– press MUTE again;
– adjust the volume controls;
– change to another source.
DIGITAL TUNER (See 3)
Tuning to stations
1. Press STANDBY ON y to on, then press
SOURCE once or more to select TUNER (or press
TUNER once on the remote control).
= Display: shows
waveband, frequency, and preset station
number if already stored.
2. Press BAND / DISPLAY once or more to select your
waveband ( TUNER on the remote control)
3. Tuning to stations: you can tune to your
stations manually or by automatic search tuning:
Press down on ∞ or § (5 or 6 on the remote
control ) and release button when the frequency in
the display starts running.
= The radio automatically tunes to a station of
sufficient reception. Display shows
during automatic tuning.
4. Repeat step 3 if necessary until you find the
desired station.
• To tune to a weak station, press ∞ or § (5 or
6 on the remote control ) briefly and repeatedly
,
,
.
.
briefly followed by
until you have found optimal reception.
To improve radio reception:
• For FM, extend, incline and turn the telescopic
antenna. Reduce its length if the signal is too
strong.
• For MW, the set uses a built-in antenna. Direct
this antenna by turning the whole set.
Programming tuner stations:
You can store up to a total of 30 radio stations in the
memory, manually or automatically (Autostore).
Autostore
Automatic programming will start from preset 1. The
set will only program stations which are not in the
memory already.
1. Press ALBUM / PRESET- or + once or more to
select the preset number .
2. Press PROG for 4 seconds or more to activate
auto store programming.
= Display:
stations are programmed in order of waveband
FM, followed by MW , preset 1 station will
then be played after all stations are stored
automatically.
Manual programming
1. Tune to your desired station (see Tuning to
stations).
2. Press PROG to activate programming.
= Display: program flashes.
3. Press ALBUM / PRESET- or + once or more to
allocate a number from 1 to 30 to this station.
4. Press PROG again to confirm.
= Display shows the preset number, waveband
and the frequency of the preset station.
5. Repeat the above four steps to store other
stations.
Note : You can erase a preset station by storing
another frequency in its place.
To listen to a preset station
Press ALBUM / PRESET- or + once or more until
the desired preset station is displayed.
DIGITAL TUNER
is shown and available
Publicité
Table des Matières
