Rear Panel - BST CDD 500 Manuel D'utilisation

CDD 500
13. IN BUTTON
This button sets the beginning of the seamless loop
.
14. OUT BUTTON
When you press this button, you set the end point of the seamless loop and you start the loop. To finish the loop, press again this button.
15. RELOOP BUTTON
This button is used to start the last saved seamless loop. To finish the loop, press the OUT button.
16. PITCH ON/OFF BUTTON
Using this button you can validate the pitch slider's functioning (16%).
17. PITCH BEND –
When 2 CD players are playing a CD, the pitch bend function allows the positioning of the bass beats to be matched after the pitch has
been matched. The pitch will automatically rise when the + button is pressed and return to the original pitch when it is released.
The pitch will drop while the - button is pressed. By changing the pitch in this way, the positioning of the beats can be matched.
18. PITCH BEND +
When 2 CD players are playing a CD, the pitch bend function allows the positioning of the bass beats to be matched after the pitch has
been matched. The pitch will automatically rise when the + button is pressed and return to the original pitch when it is released.
The pitch will drop while the - button is pressed. By changing the pitch in this way, the positioning of the beats can be matched.
19. PITCH POTENTIOMETER
Use this fader to increase or decrease the speed of the track.
20. USB SOCKET
Connect on this socket a USB key or a USB hard drive
21. DISPLAY

REAR PANEL

1. POWER SOCKET
Used to connect the AC mains power to the unit.
2. AUDIO OUTPUT
The audio for each CD player is an output for these jacks. Connect to the line input of the mixer.
3. DIN SOCKET
These sockets are used to connect the remote control to the main unit. Use the din cable to connect it.
© Copyright LOTRONIC 2012
BSTDJ.COM
Page 8