Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.3.
Spa structure
5.3.1.
Filling the basin
The water must reach a level 20 mm higher than the water line. If this level is not reached, the heating
and filtration will not work properly. If this level is exceeded, water may overflow while using the spa.
5.3.2.
Maintaining the water in the pool
The water in the spa structure should be filtered regularly. It is not advisable to filter the water every
time.
The water in the basin must periodically undergo chemical treatment. However, chemicals containing
calcium ions should not be used. If you use chemicals with calcium ions to treat the water, it is very likely
that scale deposits will form on the walls of the tank or in the internal heating pipes. Lime deposits
directly damage the electrical components inside the control panel, and therefore have a negative
influence on the service life of this panel.
If the cumulative operating time of the filtering system reaches 168 hours, the system will sound an
alarm to remind the user to clean or replace the filter.
5.3.3.
Storing the spa
Completely empty the water in the tank and wipe off any droplets on the walls.
Then let the spa stand for 24 hours, deflate it and fold it up. In winter, please fold the spa inside. In fact,
in winter, the very low temperature causes hardening of the spa materials. In this case, bending the spa
may cause the materials to break. Return the spa to its packing carton after folding it, and place the
carton in a shaded area to avoid direct exposure to sunlight.
17
Publicité
Table des Matières
