Playing A Disc - RCA DRC99731U Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing in a Vehicle
Mounting in the Vehicle
Use the supplied mounting straps to install the DVD player and the
monitor on the back of the vehicle's headrests. Tightly wrap the
mounting strap around the headrest.
Mounting the DVD Player
Mounting
strap
Mounting the Monitor
Mounting
strap
Installation Guide
DVD Player
Car Power Adapter
with splitter
Remote
Control
SAFETY WARNING!
• This unit should never be used by the vehicle's driver or left
unsecured in the vehicle while driving.
• If this unit is being used in your vehicle, be sure that it is secured
or held safely, and does not obstruct any safety device, including
air bags or seat belts.
• All passengers should wear seat belts when using this unit in a
moving vehicle.
• If in doubt, please contact your vehicle manufacturer for further
advice.
All manuals and user guides at all-guides.com
Mounting
strap
Mounting
strap
Monitor
Mounting
Straps
Built-in
AV cable

Playing a Disc

This owner's manual explains the basic instructions for operating
this unit. Some DVDs are produced in a manner that allows specific
or limited operation during playback. Therefore, this unit may not
respond to all operating commands. THIS IS NOT A DEFECT. Please
refer to the instructions accompanying the specific DVD in question
for more information about the options available on that DVD.
"
" may appear on the screen during operation. A "
that the desired operation is not permitted by the unit or disc.
Playing a Disc
1. Slide the
/ STANDBY / ON switch on the top of the unit to the ON
position. (Slide the ON/OFF switch on the monitor to the ON position.)
See
CUSTOMIZING THE FUNCTION SETTIGS
to step 2.
2. Press the
OPEN button and hold the front panel to open the disc door.
3. Hold the disc by its edge and gently push it onto the spindle, with
the label side facing the front, until you hear a "click".
4. Push the disc door gently to close it. It takes a short while for your
unit to load the disc. After loading, for most DVDs, the unit will
automatically take you main menu or start playing. If the unit does
not automatically start playing the DVD, press the
Pausing Playback (Still Mode)
Press the
PAUSE button. To resume normal playback, press the
PLAY button.
Each time you press the
frame on a DVD.
Stopping Playback
STOP button at the location where you want to interrupt
Press the
playback. To resume playback at the position where the disc was
PLAY button.
stopped, press the
If you press the STOP button twice, the unit's memory will be cleared
and pressing the
PLAY button will reset the disc to the beginning.
Stopping Playback in DVD/CD/DIVX
• During playback, press the
you want to interrupt playback. Press the
resume playback at the position where the disc was stopped.
• Press the STOP button twice to clear the unit's memory. Pressing
the
PLAY button will play the disc from the beginning.
• Pressing the STOP button three times will change to next mode.
Stopping Playback in Picture Files
• During playback, press the STOP button will change back to File list.
• During playback, press the
next mode.
Fast Forward / Fast Reverse
1. Press the SEARCH
playing. Each time you press the SEARCH
button, the playback speed changes in the following sequence:
x2
x4
x8
x20
2. Press the
PLAY button on the remote control or press the
button on the unit when you reach the desired point to resume
normal playback.
Notes:
• The DVD player mutes sound and subtitles during reverse and
forward scan of DVDs.
• The fast playback speed may differ depending on the disc.
Skip (Forward / Reverse)
NEXT button to advance titles, chapters/tracks.
• Press the
PREV button to go back to current or previous titles,
• Press the
chapters/tracks.
• For an Audio CD, use the number buttons on the remote control
to go directly to the desired track number.
Audio Selection
On some DVDs, the sound is recorded in two or more formats. Follow
the directions below to select the preferred language and sound system.
1. While a disc is playing, press the AUDIO button to show the
current audio format number.
2. Press the AUDIO button
repeatedly to select the
desired audio format.
- 7 -
DVD
before proceeding
PLAY button.
PAUSE button, the picture advances one
STOP button at the loaction where
PLAY button to
STOP button twice will change to
or
SEARCH button when a disc is
or
x2
x4
x8
[ 1 ENGLISH
" means
EN
SEARCH
x20
D5.1CH ]

Publicité

Table des Matières
loading

Table des Matières