Pulsar APS 5 Manuel De L'utilisateur page 2

Battery Pack APS 5
APS 5 rechargeable lithium-ion power supplies are designed for use with PULSAR thermal imaging devices. APS 5
batteries support USB Power Delivery fast charging technology when using a standard charging set (charger, USB
Type-C cable, power adapter). The rechargeable battery can be used separately or with a cover lock (supplied with
the device). It depends on the device.
PACKAGE CONTENTS Model
•
APS 5 battery SKU
• Operating Manual Type
Nominal capacity at +22°С (72°F)
Rated voltage
Charge/discharge cycles, minimum*
Charge/discharge ambient temperature
Dimensions
Weight
Improvements may be made to the design of this product to enhance its user features.
The current version of the Operating Manual can be found on the website www.pulsar-vision.com
BATTERY CHARGING
• Insert the battery (1) along the guide to the stop into the APS 5** charger slot (4) (see. Fig.).
• Connect the plug of the USB Type-C cable** (7) to the USB Type-C connector of the power adapter** (3). Plug the
power adapter (3) into a socket 100-240 V (110 V for US) (6).
• Connect the other end of the USB Type-C cable to the USB Type-C connector (5) of the charger (4).
• LED indication (2) will display battery charge level (see Table).
• Two batteries can be charged at the same time: the second slot is designed for it.
LED indication (2) in battery charging mode
Battery level is from 0% to 25%
Battery level is from 26% to 50%
Battery level is from 51% to 80%
Battery level is from 81% to 99%
The battery is fully charged. It can be
disconnected from the charger.
Defective battery. It is forbidden to use the
battery.
Attention! When using a power adapter that does not support USB Power Delivery fast charging technology, the
flicker frequency of LED indicators is reduced by 3 times.
Attention! The charger heats up during fast charging. Excess heat is removed through the radiator and does not
affect the device operation.
PRECAUTIONS
• Always use the APS 5 charger supplied with the device (or purchased separately) to charge APS 5 batteries. Using
the unsuitable charger can cause irreparable damage to the battery and fire.
• Do not charge the battery immediately after brining it from cold to warm. Wait at least 30 minutes for the bat-
tery to warm up.
•
Do not leave the battery unattended while charging.
•
Do not use the charger if it has been modified or damaged.
• Do not leave the battery in a charger connected to the network after charging is complete.
•
Do not expose the battery to high temperatures and naked flame.
•
Do not use the battery as a power source for devices that do not support APS 5 batteries.
• Do not disassemble or deform the battery.
•
Do not drop or strike the battery.
•
Do not submerge the battery.
• Keep the battery out of the reach of children.
APS 5
79181
Li-ion
4900 mAh
3.7 V
500
0°С...+35°С/-25°С...+50°С
(+32°F...+95°F/-13°F...+122°F)
84 х 25 х 25 mm (3.3 x 1 x 1 inches)
0.08 kg (2.9 oz)
LED indication (2) in standby***
Battery level is from 0% to 25%
Battery level is from 26% to 50%
Battery level is from 51% to 80%
Battery level is from 81% to 99%
The battery is fully charged. It can be
disconnected from the charger.
Defective battery. It is forbidden to use the
battery.
RECOMMENDATIONS FOR USE
• The battery should be partially charged for long-term storage – 50 to 80 %
•
The battery should be charged at an ambient temperature of 0°C...+35°C (+32°F...+95°F). Otherwise, lifes-
pan of the battery will decrease significantly.
•
When using the battery at sub-zero temperatures, the battery capacity decreases, this is normal and not
a defect.
•
Do not use the battery at temperatures outside the range of -25°С...+50°С (-13°F...+122°F) – this may
reduce battery's life.
•
The battery has a short-circuit protection. However, any situation that may cause short-circuiting should
be avoided.
* Once reached the specified limit, the battery capacity may drop to 80%. This is normal and not a defect.
** Purchased separately or supplied as package contents of a device.
*** Standby mode – an operating mode in which batteries are inserted into the charger, but the power
adapter is not connected. In this mode, the indication is on for 10 seconds.
1 4
6
3
7
2
5
2