Publicité
GENERAL INSTALLATION DATA
This equipment is designed and sold for commercial
use only by personnel trained and experienced in its
operation and is not sold for consumer use in and
around the home nor for use directly by the general
public in food service locations.
Ultra-Max series griddles are equipped for use on
either natural or propane gas. This unit is shipped for
propane gas and can easily be converted to natural.
See Natural Gas - Conversion.
-IMPORTANT-
Be sure to remove all paper protection and packing
material from unit prior to lighting.
protective plastic from the griddle plate and thoroughly
clean the unit's exterior surfaces.
KEEP THE APPLIANCE AREA FREE AND
CLEAR FROM COMBUSTIBLES!
non-combustible countertops only. Combustible and
non-combustible material must be at least 48" (120cm)
from the top of the appliance and at least 6" (16cm)
from the sides and back. Adequate clearance should
also be provided for proper operation and servicing.
The installation of the Appliance must
conform to the NATIONAL FUEL GAS CODE
"ANSI Z223.1 - LATEST EDITION" AND
ALL LOCAL GAS COMPANY RULES AND
REGULATIONS.
IN CANADA INSTALLATION SHALL BE IN
ACCORDANCE WITH THE CURRENT CAN/
CGA-B149.1 NATURAL GAS INSTALLATION
CODE OR CAN/CGA-B149.2 PROPANE
INSTALLATION CODE AND LOCAL CODES
WHERE APPLICABLE.
CAUTION
Remove the
For use on
When this appliance is installed with casters, it must
be installed with the casters supplied, a connector
complying with either ANSI Z21.69 or CAN/CGA-6.16
and a quick-disconnect device complying with either
ANSI Z21.41 or CAN1-6.9. It must also be installed
with restraining means to guard against transmission
of strain to the connector.
For your protection, we recommend a qualifi ed
installing agency install this appliance. They
should be familiar with gas installations and your
local gas requirements. In any case, your gas
company should be called to approve the fi nal
installation.
This appliance, its pressure regulator and its individual
shutoff valve must be disconnected from the gas
supply piping system during any pressure testing of
that system at test pressures in excess of 1/2 PSIG.
This appliance and its pressure regulator must be
isolated from the gas supply piping system by closing
its individual manual shutoff valve during any pressure
testing of the gas supply piping system at test pressures
equal to or less than 1/2 PSIG.
EXHAUST CANOPY
Griddles inherently create a good deal of heat and
smoke and should be installed under an effi cient
exhaust hood with fl ame proof fi lters. A vertical distance
of not less than 48" shall be provided between the top
of the appliance and fi lters or any other combustible
material. Exhaust installation must conform to local
codes.
AIR SUPPLY
Provisions for adequate air supply must be
provided.
AIR INTAKES IN BOTTOM
Air for combustion enters from the bottom of the unit.
Do not obstruct this area.
6
NOTICE
CAUTION
Publicité
