Lindy Switch 2 Port Dual Head DP 1.2 KVM Manuel Utilisateur page 5

User Manual
Overview
Front Panel
Switch: Pressing this button will switch control from PC1 to PC2, repeating this will alternate between
source devices.
PC1 LED: This LED Illuminates when a connection to PC1 is established.
PC2 LED: This LED illuminates when a connection to PC2 is established.
Rear Panel
The rear panel is split into three sections. Output, PC2 & PC1 as you look from left to right.
USB Input and Storage devices can be connected to the Output USB Type A (Female) Ports, Output
displays connected the Output "A" & "B" Ports.
Source devices are connected the USB Type B Ports "PC1" & "PC2" and video outputs connected to the
PC1 & 2 DisplayPort (Female) Ports.
Installation & Operation
For installation of this KVM switch, please follow the steps below. To avoid issues, it is recommended that
all devices are turned off prior to the initial setup.
1. Using two USB Type A to B cables, Connect the source PC's to the KVM switch using ports "PC1" &
"PC2".
2. Connect two DisplayPort cables from the source PC's to Ports "A" & "B" Above PC1 & PC2.
3. Connect two DisplayPort Displays to the KVM Switch's Output Port "A" & "B" high quality DisplayPort
cables.
4. Connect appropriate USB devices to the Output USB Type A Ports.
5. Attach the appropriate multi-country adapter to the included 5VDC 2A power supply, then connect the
screw type DC jack to the DC5V port on the switch, and the power supply to a DC mains outlet.
6. Power on the KVM switch, source & display devices.
This completes installation. To switch between source devices, simply press the "Switch" button on the
front of the device or select the desired source using the IR remote control.
English