i-tec USB-C/A Dual Display Docking Station Mode D'emploi page 6

EN
6. 1x Ethernet GLAN RJ-45 port for fast network and Internet access with
Gigabit Ethernet connection, it supports speeds of 10 / 100 / 1000 Mbps
7. Graphic interface: 2x HDMI and 2x Display Port. Docking station
supports up to two monitors.
Resolution:
- 1 monitor connected via 2 DP cables: 1x DP + 1x DP supports up to 5K
5120 x 2880/60 Hz, a graphics card on your computer must support
5K resolution
- 2 monitors connected at the same time: 1x DP + 1x DP supports up to 4K
4096 x 2160/60 Hz; 1x DP + 1x HDMI supports up to 4K 4096 x 2160/60 Hz;
1x HDMI + 1x HDMI supports up to 4K 4096 x 2160/60 Hz
8. 2x USB-A 3.0 port for connecting USB 3.1/3.0/2.0 devices and high-speed
data transmission up to 5 Gbps; supports USB Hot Swapping function
9. USB-C port for connecting to a laptop with the USB-C or USB-A
interface, both connecting cables are included
Side panel:
10. Kensington lock
• Chipset: DisplayLink DL6950, VIA Vl813
• Product dimensions: 223 x 88 x 27 mm
• Product weight: 338 g
INSTALLATION IN WINDOWS 7/8/8.1/10 AND HIGHER, MACOS, LINUX
AND OTHERS
The HUB is installed automatically, no need install drivers. Plug the HUB via
USB-C 3.1, gen. 1 cable into available USB-C port of your notebook/PC and
follow the on-screen instructions. The HUB will be installed and displayed in
Device manager as "Generic USB Hub" and "Generic USB SuperSpeed Hub".
CHARGING
The HUB supports charging of the connected USB mobile equipment such
as smartphones (including iPhone and Samsung phones), e-book readers,
multi-media players, GPS navigators, and tablets (e.g., Asus, Toshiba, Go-
Clever, Prestigio, Emgeton, Sencor). Using the original cable connect the
equipment to be charged to the USB port of the HUB.
6
Quick Start / USB 3.0/USB-C Dual Display Docking Station