Start-Up And Use - Lagrange 50903 Serie Notice

START-UP AND USE

ST USE
1
Fully extend the cable and examine it carefully before using it.
*
Fill the appliance with water to the maximum level («MAX»).
*
Switch on the appliance as described in the section «Using the
*
appliance». Let the water boil.
Pour out the water after it boiled.
*
Repeat this procedure.
*
Your appliance is now ready to use.
*
USE OF THE UNIT
Open the lid by using the handle.
*
Fill the kettle with water to the desired level while observing
*
the specified levels ( . L MIN to
0 6
water through the spout. This improves filter maintenance.
Caution: do not use without water!
Close the lid and make sure it is firmly closed.
*
Place the appliance on its base.
*
Power up the appliance by connecting the power plug.
*
Press the ON/OFF switch to turn on the kettle. Its blue pilot light
*
turns on.
The kettle will turn off automatically once the water has reached
*
the boiling point. However, you can also turn it off manually at
any moment. The blue pilot light will turn off.
Suggestion: you can shorten the length of the cord using the
storage compartment provided under the base.
. L MAX). You can fill with
1 7
Boil-dry protection device
If the MIN water level is not observed, the boil-dry protection
device, which is the kettle's safety mechanism, will be activated,
turning the kettle off. In this case, disconnect the kettle and wait
for minutes before using it again.
15
Water temperature gauge
The water temperature gauge lets you know the temperature
of the water inside the kettle. Use the gauge when you prepare
beverages that require different temperatures of water such as
green teas, white teas, coffee, etc. The gauge will not work if
there is an insufficient quantity of water in the kettle (less than
the minimum level).
38