Use Of The Unit - Lagrange 509001 Notice

STARTING AND USE
BEFORE THE USE
ST
1
Fill the unit with water up to the maximum level ("MAX").
*
Turn on the unit as described in the section "use of the unit".
*
Let the water boil.
Pour out the water once it has boiled.
*
Repeat the operation a second time.
*
The unit is ready for use.
*

USE OF THE UNIT

Open the cover using the button.
*
Fill the unit with water up to the desired level, observing the
*
level requirements.
Close the cover and make sure that it is properly locked in place.
*
Put the kettle on its base.
*
Turn on the unit by plugging it in. The
*
go on.
Adjust the temperature using the setting button. There are
*
temperature choices: °C,
4 40 60
indicator will go on once the temperature has been chosen.
Press the on/off button.
*
When the temperature indicator is flashing, the water is heating up.
*
• Once the selected temperature has been reached, the indicator
light stops blinking and stays on.
• The use can be interrupted at any time by pressing the on/
off button.
• By default, the unit is programmed to heat to
this temperature, press the on/off button.
100 °C indicator light will
°C, °C, and °C. The temperature
80 100
100 °C. If you want
Once the water has come to this temperature, you can maintain
*
it by pressing the keep warm button.
• Adjust to the desired temperature, press the keep warm button
and then the on/off button.
• Once the keep warm function has been activated, the button will
light up. The function can be deactivated by pressing the keep
warm button again or by pressing the on/off button. The keeping
warm time is 2 hours.
• When the keep warm function is activated, the temperature
cannot be changed.
• The unit keeps the keep warm temperature used in memory.
If you want to modify this temperature, you must do so during
a new use of the unit.
• The unit can be adjusted to heat the water and then keep it warm.
To do this, press the temperature selection button, then select
the temperature maintaining mode, then turn on the kettle with
the on/off button to heat the water. Once the water is heating,
the temperature button flashes until the water is hot, and then
the light becomes constant. The temperature maintaining button
goes from stable to blinking. The unit goes into keep warm mode
once the temperature has been reached.
Advice: You can wind the cord up in the storage support located
under the base.
Anti-dry boiling system
If the water is not at least at the "MIN" level, the kettle will not
start: this is the anti-dry boiling safety system.
46