Zyxel P-660HNU-F1 Guide De Démarrage Rapide page 5

3. USB 2.0: You only need to use this port if you are connecting a USB
storage device, USB printer or a 3G adapter to the P-660HNU-F1.
4. POWER: Use the power adaptor provided with your P-660HNU-F1 to
connect this socket to an appropriate power source.
5. Push the power button to the on position and look at the LEDs (lights)
on the top panel of the P-660HNU-F1.
• The POWER light blinks during start-up and stays on once the P-
660HNU-F1 is ready.
• The ETHERNET light turns on if the corresponding ETHERNET
port is properly connected. If you do not connect a computer
correctly to this port, the ETHERNET light will not turn on.
• The WLAN/WPS stays on when the wireless LAN is ready. The
light will not turn on if the Wireless Connection is not activated.
The ETHERNET and WLAN/WPS lights blink when the P-660HNU-F1 is
sending or receiving data. If the POWER light does not turn on during
start up, try turning the P-660HNU-F1 off, check the connections, wait a
few seconds and then turn it back on. If the problem persists, you may
have a hardware problem and you need to contact your vendor.
ENGLISH
5