Installation Instructions - Lithonia Lighting OMS 1000 Instructions D'installation

All manuals and user guides at all-guides.com

installation instructions

1. remove all components and parts pack from packaging.
Check to ensure all parts are included. Note: Account for small
Basic wiring DiagraM
parts and destroy packing material, as these may be hazardous to
children.
turn off Power at circuit breaker box.
caution: Do not rely on wall switch alone to turn off power.
Note: Motion sensor can be mounted to an eave or wall mount UL
listed junction box.
2. Thread the motion sensor into UL Listed mounting plate or
Basic wiring witH BackPlate
junction box with a 1/2" NPT threaded plug. Mounting plate sold
separately.
Multiple fixtures may be wired to a single sensor. To handle loads
greater than the wattages listed in specs, a qualified electrician
should install a relay.
wiring tHe Motion sensor
Make sure power is turned off.
3. Use included UL listed connector to connect the (copper) house
supply ground wire & the (green) mounting plate ground wire.
Note: If house wiring does not include a ground wire, consult your
local electrical code for approved grounding methods.
For proper connection, place wire nut over
wires and twist clockwise until tight.
4. Use included UL listed connector to connect the black lamp
head wires to the red motion sensor wires.
MultiPle fiXture wiring
5. Use included UL listed connector to connect the white
lamphead & white senor wires to the white power supply wire then
connect the black sensor wire to the black supply wire.
6. install mounting plate to junction box.
Note: Lamp heads must be positioned above motion sensor head
and controls on motion sensor must face the ground.
7. turn on electricity at fuse or circuit breaker box and verify
success of installation.
8. apply silicone caulking (not included) around the perimeter
of the mounting plate and junction box where it contacts the
mounting surface for moisture seal.
see next pages for Motion sensor set uP instructions
page 3