Dab/Fm Operation - auna CDC-200 Mode D'emploi

To power off mode
When the unit is in the power standby mode. Press and hold the STOP /
POWER OFF button. The unit will enter the Power off "Bye Bye" mode.
Earphones connection
Connect the plug of the stereo earphone (included) into the EARPHONES
JACK.
CAUTION: Danger of hearing impairment
Avoid excessive volume levels for long period of time when
using the earphones. Prolonged use at high levels may
impair your hearing. Do not use earphones while operating
a motorized vehicle, as it may create a traffic hazard and is
illegal in many areas.

DAB/FM OPERATION

Switching to SOURCE mode
1. The first time the DAB Digital Radio is switched, it will start up DAB
mode.
2. If the DAB Digital Radio is in DAB mode, press the SOURCE button
repeatedly until FM is shown on the display.
3. Once in FM mode, your DAB Digital Radio will tune to the start of the
available FM range (87.50MHz) or the last FM station lited.
4. To manually change the FM frequency, make sure that you have not
selected any other sub-menus. Turn the TU+/- to change the frequency
by 0.05 MHz.
Changing the dab display information
1. If the in DAB mode, press MENU/INFO button to select different info
to show on the display, such as DLS (Dynamic Label Segment), signal
strength, PTY (Program me Type), ensemble, frequency, signal quality,
bit rate codec, time, date.
2. If the in FM mode, press MENU/INFO button to select different info to
show on the display, such as Radio text, PTY (Program me Type), stereo/
mono, time, date.
EN
27