Polk magnifi Guide Rapide page 9

IR Remote Learning
For your sound bar to respond to your remote control, you MUST FIRST
program the bar to respond to your television's original IR (Infra-Red) remote.
An RF (Radio Frequency) remote will not work. Other remotes (cable, satellite)
will work only after you have programmed the bar to respond to the TV's IR
remote.
Note: If your bar fails to learn certain IR remote codes, the LED will blink red. LED's then exit the learn
mode after attempting to connect. Carefully repeat steps 1-3 below.
1
Enter Learn mode by
pressing and holding
the source button for
3 seconds.
Code Erasing Procedure: If you have programmed your Sound bar to
respond to a remote control and you no longer want it to do so, erase the
codes by pressing the SOURCE key for about 10 seconds while the unit is
in standby mode (LED's will flash fast, alternating amber/white 3 times per
second for 2 seconds). When sequence is complete you'll know that previously
learned codes have been successfully erased.
8
2 3
Press the volume Corresponding function should be
up button. pressed repeatedly, and 4 LED's will flash
immediately after each press. LED's will
flash white 3 times within 1 second then
hold solid for 2 seconds for success.