Chicco WE Mode D'emploi page 8

INSTRUCTIONS
FOR USE
IMPORTANT - READ CAREFULLY AND
KEEP FOR FUTURE REFERENCE.
WARNING: BEFORE USE, REMOVE AND
DISPOSE OF ALL PLASTIC BAGS AND
PACKAGING MATERIALS
THEM OUT OF REACH OF CHILDREN.
WARNINGS
• WARNING: The adaptors can only be used
with the Chicco We stroller.
• WARNING: Only CHICCO KAILY and KIROS
I-SIZE FAST IN Child Car Seats can be installed
on these adaptors.
• WARNING: Before use, check correct fixing
of the adaptors to the frame of the stroller.
• WARNING: Before use, make sure that the
child car seat is correctly fitted on the adap-
tors by pulling up on the car seat.
• Keep adaptors out of reach of children when
they are not in use.
INSTALLATION AND USE OF ADAPTORS
WITH THE CHICCO KAILY CHILD CAR SEAT
1. Before installing the adaptors on the stroller,
remove the bumper bar.
To attach properly, the adaptor must be in line
with the lateral joint of the stroller (Fig. 1A).
Position the adaptor on the stroller frame, in-
sert the plastic tab «1» between the metal strip
and the junction.
Align the plastic eyelet «2» with the pin on the
metal strip. (Fig. 1B and 1C)
Lock the adaptor in place by closing the plas-
tic lever located on the side. (Fig. 1D). Repeat
these operations for the adaptor on the oppo-
site side as well.
WARNING: Before installing the Child Car
Seat, check that the adaptors are mounted
correctly.
2. To install the CHICCO KAILY Child Car Seat,
recline the backrest of the stroller and then
insert the lateral hooks of the child car
seat into the adaptors that were previous-
ly mounted (Fig. 2 - 2A - 2B). The car seat
should be fixed only and exclusively facing
parent.
3. To remove the Car Seat press the button on
the back and pull upwards (Fig. 3 - 3A).
INSTALLATION AND USE OF ADAPTORS
WITH THE CHICCO KIROS I-SIZE FAST IN
CHILD CAR SEAT
To install the adaptors refer to paragraph 1.
AND KEEP
4. To install the Chicco KIROS I-SIZE FAST IN
Child Car Seat, recline the stroller's backrest
and then insert the lateral hooks of the child
car seat into the adaptors previously mount-
ed (Fig. 4). The car seat should be fixed only
and exclusively facing parent.
5. To remove the KIROS I-SIZE Child Car Seat,
press the buttons under the handle on both
sides and pull upwards (Fig. 5 - 5A).
DISASSEMBLING THE ADAPTORS
WARNING: It is not possible to close the
stroller when the adaptors are mounted on
the frame.
6. To release the adaptors, turn the plastic le-
vers outwards (Fig. 6) and pull the adaptors
towards yourself. Once the adaptors have
been unhooked, the bumper bar previously
removed must be fixed back on again.
ADVICE
MAINTENANCE
The cleaning and maintenance of the product
must only be carried out by an adult.
CLEANING
After possible contact with water, dry the met-
al parts in order to avoid the formation of rust.
Do not use solvents or abrasive products for
cleaning. After use, keep the adaptor in a dry
place.
WARRANTY
The product is guaranteed against any con-
formity defect in normal conditions of use as
described in the instructions. The warranty
shall not therefore apply in the case of dam-
age caused by improper use, wear or acciden-
8
FOR CLEANING AND