Eurotops Stereo Digi+ Notice D'utilisation page 5

3.3.4
Preset recall:
3.4 MENU
3.4.1
DAB MENU
1. In DAB mode, press and hold【
2. Press 【◀ or ▶】to choose the desired menu: full scan/ manual tune/ DRC
mode/ Prune/ TA/ system (time /screen off, language, factory reset, SW
version).
【OK】
3. Press
Note: Press 【
3.4.1.1
Full scan
After proceeding with steps 1, 2 and 3 (selection: full scan) mentioned above, the radio will carry
out the full scan.
After entering one of these menus below, press 【◀ or ▶】to select a submenu/ options or
scrolling up/ down the list. Press
3.4.1.2
Manual Tune
After entering "Manual tune" menu, you will get the list of different channel frequencies from "5
A" to "13F".
3.4.1.3
DRC (Dynamic Range Control)
« DRC » is intended to control the sound or noise when listening in a noisy environment.
Note:This function may not be available on some DAB+ stations.
The 3 options for DRC are off (no compression default setting), low (medium compression) and
high (maximum compression).
3.4.1.4
PRUNE FUNCTION
This menu, only available in DAB+ mode, allows you to delete radio stations which cannot be
received well in your area (with weak signals) from the station list. After pruning operation, they
will be no longer displayed.
3.4.1.5
TA (To get information about traffic Information)
3.4.1.6
System menu (in DAB or FM MODE)
Setting sequence is as below:
The procedure is the same as in section 3.2.4:" Preset recall".
to enter.
】to exit the menu.
【OK】
(DAB mode only)
】enter DAB menu list.
to confirm
5