Operating The Unit; Removing The Collected Water - NORDIK 87795065 Guide De L'utilisateur

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
When the unit is off and the bucket is full, the unit will
beep 8 times, the Full indicator light will flash and the
digital display will indicate P2.
When the unit is on and the bucket is full, the compressor
,
turns off and the fan turns off after 30 seconds for to dry
the water on the condenser coils. Then the unit will
beep 8 times, the Full indicator light will flash and the
digital display will indicate P2.
Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the bucket on the floor
because the bottom of the bucket is uneven. Otherwise
the bucket will fall and cause the water to spill.
Pour out the water and reinstall the bucket. The bucket
must be in place and securely positioned for the
dehumidifier to operate.
The machine will re-start when the bucket is
in its correct position.
NOTES:
When you remove the bucket, do not touch any parts
inside the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may prevent the unit from operating.
Any water found in the bucket at removal must be dried.
2. Continuous draining
Water can be automatically emptied into a floor drain
via a drain hose ( I.D.
female end (I.D.
26mm
Make sure the drain hose is attached to adaptor A (See Fig. 7,
placed in the bucket).
Remove the plastic cover from the back drain outlet of
the unit and remove bucket, then insert the drain hose
into the drain outlet of the unit and securely press it
onto the connector on the front of the unit.(See.Fig. 9)
Tighten the adaptor A and the unit by using two screws
(placed in the bucket).
Install the female threaded end of the water hose
(not included)
adaptor A (See.Fig. 10),then place the
water hose in the floor drain or a suitable drainage
Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain, making sure that
there are no kinks that will stop the warter from flowing.
Place the end of the hose into the drain and make sure
level with the dehumidifier or lower so the water flows
smoothly. Make sure it is not pointing upwards.
Place the bucket back in the unit and make sure
that it is positioned correctly.
Select the desired humidity setting and fan speed
on the unit for continuous draining to start.
NOTE: When the continuous drain feature
is not being used, remove the drain hose
from the outlet.

OPERATING THE UNIT

8mm (5/16˝) ,not included) w i th a
,not included).
(1˝)
1. Pull out the bucket a little.
2. Holding both sides of the bucket,
Drain hose
Plastic cover
Drain hose
subassembly
opening.
Connector
Drain hose
8
Fig.5
pull it out from the unit while
keeping it level. .
Fig.6
3. Pour the water out.
Adaptor
Fig.7
Fig.8
Fig.9
Water hose
d
Female threaded end
Fig.10
A