Bluetooth™ Smart Device; Brightness Control; Lamp Color Control; Fade / Multicolor Fade - YORKVILLE LP-LED2M Manuel De L'utilisateur

Bluetooth™ Smart Device
You must install the Yorkville LP Control App on your smart device prior to use. The App is available on the
Apple App Store and the Google Play Store.
The Bluetooth™ app may change and this description may not reflect the particular version the user has.
There also may be additional features and the details that may change. The number of bars connected may
change along with a number of factors such as: the digital device (phone or tablet), the software version in the
bar / Bluetooth™ receiver and the amount of Bluetooth™ traffic in the vicinity.
To connect to a light bar, simply open the dedicated app and tap on the "Add Bar" button at the top of the
screen. It will prompt you to enter a 4-digit pin code - if a bar is currently unsecured, any desired pin code can
be entered. Security pin codes are cleared when the light bar is powered off, or can be removed from the app.
You can connect up to 4 bars at once.
Once at least one bar has been connected, "help" and "connected devices" buttons will appear beside the "Add
Bar Button," along with: channel selection, individual head controllers, effects selection, and scene selection.
Channel Selection
Four channels are available, labeled A, B, C and D. These correspond with the channel each light bar
has been set to on the back of the bar. Any bar set to the currently selected channel will follow given
commands. For example, if two bars are connected and set to channel A, changing the first head color to
red will cause the first heads on specifically those two light bars to become red.
Individual Head Controls
The controls will appear as a color knob, an intensity slider, and a manual RGBW assignment button.
Rotating the knob will cycle through the corresponding wheel colors, adjusting the intensity will affect the
brightness level, and pressing the RGBW button will allow for manual RGBW color assignments.
Effects Selection
Eight effects are available. The first seven correspond with the effects on the light bar, while the
eighth is an additional strobe effect. Individual head controls are disabled for that channel and scene
until the effect is switched off.
Scene Selection
Each scene will retain the configured head controls or effect for all 4 channels. 10 scenes are available,
and are automatically saved to device storage.

Brightness Control

The brightness of all pods vary from a minimum to a maximum with 32 positions. This control varies the bright-
ness of all pods from any function position or any control source.
Note: The maximum brightness controlled by DMX or the Bluetooth™ app will depend on the manual
brightness setting on actual light bar.

Lamp Color Control

If using the Lamp Color control, any pod can be turned off by setting the Color control to the off position. There
are 31 colors and color choices which begin with red, followed by blue, white, amber yellow and finally green.
There are also several choices of color temperature for white.

Fade / Multicolor Fade

The color fade speeds are fairly slow and are intended for gradually changing the lighting for a mood effect,
chase speeds are faster and are also multi-color.

Color Sound to Light

The LP-LED Bars have sophisticated audio to light (color organ) circuitry. The automatic level circuitry allows it
to be used with signals from weak line levels up to strong loudspeaker levels. The voltage range on the ¼-inch
phone jack is 50mV to 100V. The LP-LED Bars has an internal microphone with automatic sensitivity. The mi-
crophone triggers the same sophisticated audio to light (color organ) circuitry as is used in the audio input jack.
Note: the microphone is active unless a ¼-inch phone jack is inserted to the audio input.

Mounting

For mounting on a standard loudspeaker stand please refer to the diagram "LP-LED Overhead Truss Mounting
Instructions for Tripod Speaker Stand." The stand adapter has a removable pin to allow multiple light bars per stand.
For overhead truss mounting please refer to the diagram "LP-LED Overhead Truss Mounting Instructions."
As shown in the diagram you must use a safety cable to protect people and equipment in case the primary
LP -LED/X/M
2