Convenience Receptacle - English - YORKVILLE LP-LED2M Manuel De L'utilisateur

Table des Matières

Les langues disponibles

L P - L E D 2 M C o n v e n i e n c e

P o w e r R e c e p t a c l e

The LP-LED2M provides a convenience outlet which can minimize wiring and improve overall safety when used prop-

erly. Please carefully read all of the important safety tips shown below for long and safe use of your lighting equipment.

IMPORTANT

1. Do not overload the convenience outlet. Make sure power drawn from the first outlet does not exceed

the limits shown on the chassis. Some acceptable combinations are shown below.

8.0A

LP-LED2M

2.0A

2. Always inspect the cords and plugs before use. Do not use outlets or cords that have exposed wiring, are

worn or damaged. Replace electrical cords that have worn or damaged insulation and remember to pull

the plug, not the cord to extend the life of the cord itself.

3. The mains plug of the power supply cord shall remain readily operable. It is important that the user can

quickly get to the ac plug and disconnect the unit in the case of an emergency.

4. The AC supply cord should be routed so that it is unlikely that it will be damaged. Protect the power cord

from being walked on or pinched. If the AC supply cord is damaged DO NOT OPERATE THE UNIT. To

completely disconnect this apparatus from the AC Mains, disconnect the power supply cord plug from the

AC receptacle. Unplug this apparatus during lightning storms or when unused for long periods of time.

Route cords away from traffic to avoid tripping hazards and unnecessary wear on the power cord.

5. Never Break Off the Third Prong on a Plug. Replace broken 3-prong plugs and make sure the third prong

is properly grounded.

6. Keep line cords away from heat, water and oil. They can damage the insulation and create a shock hazard.

7. Do not tie cords in tight knots. Knots can cause short circuits and shocks. Loop the cords or use a

twist lock plug.

8. Be aware that unusually warm or hot outlets or cords may be a sign that an unsafe wiring condition exists. Check

to ensure there are not too many devices in the chain drawing too much current from the line cord. Unplug any

cords or extension cords from these outlets and do not use until a qualified electrician has checked the wiring.