Behringer MICROMON MA400 Mode D'emploi page 3

(6)
MONITOR INPUT connector: To send a signal from a mixer or
Hi-Fi unit to the MA400, you need an audio cable that includes
¼" connectors (unbalanced/stereo TRS or unbalanced/mono TS).
Plug:
• •
one XLR connector into the MIC INPUT connector
• •
the other ¼" connector into the AUX SEND of a mixer or,
alternatively the output of a Hi-Fi unit
(7)
¼" PHONES connector,
To connect headphones to the MA400, use the ¼" or,
alternatively the 1/8" PHONES connector.
◊ ◊
Do not simultaneously use both PHONES connectors.
(9)
MONO / STEREO switch: To specify the type of mixer or Hi-Fi
signal the MA400 receives, use this switch. If you plugged:
• •
a TS connector into the MONITOR INPUT, the MA400
receives a mono signal. Push this switch to MONO.
• •
a TRS connector into the MONITOR INPUT, the MA400
receives a stereo signal. Push this switch to STEREO.
(10)
MIC LEVEL control: To adjust the volume of the microphone
signal, slowly turn this control toward 0 (minimum volume) or,
alternatively 10 (maximum volume).
(11)
MON LEVEL control: To adjust the volume of the mixer or Hi-Fi
signal, slowly turn this control toward 0 (minimum volume) or,
alternatively 10 (maximum volume).
SERIAL NUMBER: To register your unit, use the serial number
that is located on the bottom of the MA400.
(8)
1/8" PHONES connector:
MICROMON MA400
3