Beha-Amprobe AT-6000-EUR Manuel De L'utilisateur page 33

5. MAINTENANCE
Transmitter fuse replacement:
� Warning:
leads before opening case.
1. Disconnect all test leads from the AT-6000-TE Transmitter.
2. Make sure that the transmitter is turned off.
3. Use the star screw driver to unscrew the tilt-stand screws.
4. Remove battery door and remove all batteries.
5. Use the star screw driver to unscrew holding screws.
6. Remove the back cover by pulling it upwards as shown in figure 5.0c.
5. Remove the fuse from the fuse holder.
6. Insert the new fuse in the fuse holder. 1.6A, 700V MAX, FAST 6X32MM
7. Insert the back cover and secure it with the holding screws and tighten with the star
screw driver.
8. Reinstall the batteries and battery door.
9. Reinstall the tilt-stand.
Figure 5.0c: Transmitter fuse replacement
To avoid shock, injury, or damage to the Transmitter, disconnect test
29