Power Fist 8784738 Manuel De L'utilisateur page 7

V4.0
TANK PRESSURE TABLE
This table is a guide for recommended starting pressures. Individual tires may
require higher or lower pressures. Increase pressure if the lire bead seater does
not lift the tire bead far enough. Decrease pressure if the tire bead appears to
seat at first and then falls off again.
VEHICLE TIRE TYPE
TYPE EXAMPLES
16-650-8
ATV
22-11-8
25-12-9
24-9-11
16-650-8
Lawn Tractor
23-1050-12
26-12-12
13 in. rims
Car
14 in. rims
15 in. rims
4x4
16 in. rims
11-22-5
Truck
18-22-5
Up to 28 in.
Tractor
Over 28 in.
Large Tractor Terra Tries
48-31-20
66-43-25
Visit www.princessauto.com for more information
5 Gallon Tire Bead Seater/Blaster
SUGGESTED TANK
PRESSURE
40 psi (2.7 bar)
40-50 psi
(2.7-3.4 bar)
50-60 psi
(3.4-4.1 bar)
60-80 psi
(4.1-5.4 bar)
100 psi (6.8 bar)
120 psi (8.2 bar)
100 120 psi (8.2 bar)
psi (6.8 bar)
120 psi (8.2 bar)
TIPS
Fit on stand with stand in
highest position. Can be
fitted with the valve at the
bottom.
Use the stand in the
highest position.
If difficult, lean the rim
against the stand instead of
placing it on the stand.
Ensure the valve is
covered. Lubricate well.
Fit in vertical position.
Lubricate well. Ensure the
valve is covered by the tire.
Can be fitted vertically,
such as still on the truck.
Rotate the tire bead seater
barrel to the correct
position. If using a stand,
place it in the lowest
position.
Fit horizontally. Place the
bottom bead on the rim.
Use the tire wedge.
Fit vertically. Roll the tire
until the back bead is in
position.
8784738
7