Troubleshooting; Housing Technical Characteristics; Maximum Specifications Of The Installable Camera With Lens - VIDEOTECH EXH Manuel D'instructions

8 Troubleshooting

Although the housing series EXH is characterised by a great ease of use, sometimes troubles may
occur, especially during the installation and configuration phases or using the unit.
PROBLEM
Camera do not turn on
Camera turn on bat no video
signal
Lens do not work
Heater do not work
Image from camera do not
correct

9 Housing technical characteristics

Inside housing dimensions
(Ø x L, mm)
Housing weight
Swivel weight
Protection degree
Execution
Operating temperature
Power supply
Consumption

10 Maximum specifications of the installable camera with lens

Camera useful area (L x H x P, mm)
Max power
Max voltage
PROBABLE CAUSE
• No power supply
• Fuse blown
• Incorrect connection
• Lens power supply is not correct
or missing
• Thermostat do not set
• Incorrect connection
• Lens set not correct
• Camera working not properly
Ø 180 x 380 (460 with glass protection device)
14.5 kg (22.5 kg with glass protection device)
3.5 kg
IP 65
II 2 GD EExd IIC T6 T85°C IP 65 ATEX
Ex d IIC T6 Ex tD A21 T85°C IP 65 IECEx
-20°C ÷ + 50°C
-40°C ÷ + 50°C (Only for reinforced heater versions)
24/240 Vac, 50/60 Hz
20/40/60 W (heater housing)
100 x 100 x 280 (360 with glass protection device)
20W
240V
Attention: the housing power supply must be the same used for
the heater system
Page 11
REMEDY
• Check the power cable
• Replace fuse
• Check connection cable
• Check lens power supply
• Check thermostat temperature
• Check connection cable
• Check lens set
• Replace the camera
MNVCEXH_0702