Low Battery Indicator; Lubrication - DeWalt XR LI-ION DCL079 Traduction De La Notice D'instructions Originale

Masquer les pouces Voir aussi pour XR LI-ION DCL079:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Usage (Fig. A)

WARNING: Burn hazard. The lens and heatsink get very
hot during use. To reduce the risk of burns and fire, do not
touch and keep away from combustible materials while
in operation.
1. Place the tripod light on a stable, level surface resting on its
three extended legs.
2. To turn the light on, press the power button 
will turn on at the brightest setting. Pressing the power
button a second time will change the light to middle
brightness, and pressing it a third time will change the light
to the lowest brightness. Pressing the power button a fourth
time will turn the light off.
3. Pivot the light head as needed using the light head's frame.
4. When finished using the tripod light, press the power
button until the light turns off.

WARNING: Burn hazard. The light head's heatsink 
(Fig. D) becomes hot during use. Do not touch heatsink
when worklight is on or immediately after use, and keep
away from combustible materials. Always pivot the head
using only the head's frame.

Low Battery Indicator

As the battery nears a fully discharged state, the light will blink
twice and then dim, dropping the brightness of the light below
the normal level. The light will continue to blink twice every
45 seconds until the battery is fully discharged at which time
the light will turn off. Indication time will vary based on battery
pack capacity.

WARNING: Stop work and replace the battery when this
occurs. To reduce the risk of injury, always have a back-up
battery or secondary lighting available if the situation
warrants it.
MAINTENANCE
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
The charger and battery pack are not serviceable.
The light source contained in this light shall only be replaced
by the manufacturer or its service agent or a similarly
qualified person.

Lubrication

Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
. The light
 4 
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

WARNING: Since accessories, other than those offered
 15 
by D
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
Run the battery pack down completely, then remove it from
the tool.
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
WALT, have not been tested with this product, use
e
WALT recommended
e
EngLIsh
25

Publicité

Table des Matières
loading

Table des Matières