Setting The Alarm - Philips goLITE BLU Mode D'emploi

EnglisH
16
Pausing a session
1 Press the on/off button or press the minus button to reduce the
intensity to 0%.
The remaining minutes of the session are still shown on the display.
,
2 Press the on/off button to continue the session or press any of the
touchscreen buttons to end the session.
Note: If you pause a session while the appliance operates on battery power
and do not continue the session within 5 minutes, the appliance turns off
automatically.

setting the alarm

The alarm has three modes: chime only, light only or both chime and light.
1 Press the on/off button briefly to turn on the appliance (Fig. 6).
The touchscreen display goes on.
,
2 Press the alarm button (Fig. 12).
The alarm indications start to flash (Fig. 13).
,
3 Press the plus or minus button to switch between the three alarm
modes: chime only, light only or both chime and light (Fig. 9).
4 Press the alarm button twice or wait 10 seconds to store the
selected mode.
5 To set the alarm time, press the alarm button twice.
The alarm time starts to flash.
,
6 Press either the plus or the minus button to set the desired time. If
you keep the button pressed, the time moves forward or backward
quickly.
7 Press the alarm button or wait 10 seconds to store the set alarm
time.
Note: The set alarm mode and time remain stored in the memory as long as
there is energy in the battery.
4222.002.7504.1.indd 16 29-05-09 15:56