Using The Foot Pedal - MINN KOTA CORDED FOOT PEDAL Manuel Du Propriétaire

USING THE FOOT PEDAL

CONTROLLING SPEED & STEERING WITH THE FOOT PEDAL
The foot pedal is used to operate the motor, and controls on the foot pedal are easy to operate by either foot or hand. The motor can
also be controlled by an i-Pilot remote, or a compatible Minn Kota remote if equipped with an appropriate i-Pilot or CoPilot receiver.
Please refer to the i-Pilot or compatible remote manual on how the remote controls the motor. To learn more about accessories that are
compatible with the PowerDrive please visit minnkotamotors.com.
Steer Left
Momentary Button
Momentary Button
The Momentary Button is located at the heel end of the foot pedal and is used to turn the propeller on.
Momentary/Constant Switch
The Momentary/Constant Switch is used to toggle between Momentary and Constant Mode. During Momentary Mode (MOM),
the propeller only turns while pressure is applied to the Momentary Button. While in Constant Mode (CON), the propeller will run
continuously regardless of pressure being applied to the Momentary Button.
If a propeller encounters an obstruction while either in Momentary or Constant Mode, while the propeller is running, the increased
electrical current being generated by the obstruction will signal the motor to decrease the power to the propeller to prevent damage. If
the current overload is detected for more than 20 seconds, the prop will be disabled to prevent damage to the motor. In this event, the
operator can turn the prop back on after being sure that the obstruction has been cleared.
Speed Control
The Speed Control dial is on the upper right side of the toe end of
the Foot Pedal. Turn the Speed Knob forward to increase speed and
backward to decrease speed. Speed can also be adjusted using the
remote, if applicable.
©2019 Johnson Outdoors Marine Electronics, Inc.
Steer Right
Speed Control
Momentary/Constant Switch
CAUTION
The steering system is designed to turn your motor 360°. Be
careful to avoid over-wrapping the coil cord around the composite
shaft. Damage to the coil cord can occur when it is over-
wrapped, which will prevent the motor from operating correctly.
Foot Pedal
Connection
from Motor
Foot Pedal
Connection
minnkotamotors.com | 5