MINN KOTA CORDED FOOT PEDAL Manuel Du Propriétaire page 3

INSTALLING THE POWERDRIVE & RIPTIDE POWERDRIVE FOOT PEDAL
Your new PowerDrive Foot Pedal accessory comes with everything you'll need to directly install it on your trolling motor. These
instructions are intended to show how to install your new PowerDrive Foot Pedal on a PowerDrive trolling motor. Please review the parts
list and mounting considerations for installation prior to getting started. For additional product support, please visit minnkotamotors.com.
INSTALLATION PARTS LIST
Item /
Part # Description
Assembly
A 2994859 BAG ASY-TERROVA/V2,RUB.BUMPERS
B 2994728 FOOT PEDAL ASSEMBLY, PD
p
2377167 MANUAL-FT PEDAL, POWERDRIVE V3
2 2325110 PAD, FOOT PEDAL PD
p Not shown on Parts Diagram.
NOTICE:
The PowerDrive Foot Pedal accessory is not
compatible with motors installed with i-Pilot or i-Pilot Link.
MOUNTING CONSIDERATIONS
Before installing your PowerDrive Foot Pedal, make sure that it is compatible with your motor. To review compatibility, please refer to
the "Compatibility" section of this manual. When placing the PowerDrive Foot Pedal on your boat, select a location that will not obstruct
boat operation and that is appropriate for trolling motor operation. Place the PowerDrive Foot Pedal in a foot pedal well on your boat if it
has one, or any location where it will be free from water and debris.
INSTALLATION
Installing the PowerDrive & Riptide PowerDrive Foot Pedal
1
ITEM(S) NEEDED
#2 x 5
a. Take the Foot Pedal (Item #B) and turn it over.
Put a Foot Pedal Pad (Item #2) in each of the
pad locations.
NOTICE:
Adding the Foot Pedal pads is optional.
The pads are recommended when using the Foot
Pedal on non-carpeted surfaces.
©2019 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION
Qty.
1
1
1
5
#B x 1
B
A
Foot Pedal
Bottom
Foot Pedal
Pad Placement
2
minnkotamotors.com | 3