Powering On; Monitoring Mode; Sd Card Information - Defender STEALTH1 Manuel D'instructions

POWERING ON

1. To turn the device ON, connect the power adapter or insert batteries into the battery compartment.
2. Slide the POWER SWITCH on the top of the device to the ON position.
3. To view the menus and adjust settings, you will have to attach the included RCA cable to the VIDEO OUTPUT of the
COVERT DVR, and connect it to the VIDEO INPUT on the back of your television.
4. After powering on the system, it will automatically enter live monitoring. If the system was previously set to
SCHEDULE or MOTION, it will automatically return to that recording mode.
5. After a power outage, the system will reboot and return to the previously set recording mode.

MONITORING MODE

After start up, the system will automatically enter live monitoring mode, with the following status indicators:
1. Date and Time: Current DATE AND TIME
2. Record Status: MANUAL RECORD settings
record resolution
Please refer to RECORD SETUP for VIDEO
640
SIZE setup instructions.
480
record Quality
Please refer to RECORD SETUP or VIDEO
MQ
QUALITY setup.
3. SD Card Status:
No SD card installed or the card is malfunctioning
SD card is functioning normally
NoTe: each time the unit is powered on, the system will auto-detect the SD CArD. When the reCorD LeD is
flashing, this indicates that the SD CArD is currently being read. ALL LeDs will flash when a memory
card error is detected.

SD CARD INFORMATION

1. The SD CARD icon shown on the status line, indicates that the SD CARD is operating normally.
2. If there is a problem or error with the SD CARD, the PLAY, MENU, and REC LEDs will flash quickly. If this happens,
please re-format the SD card before proceeding (all saved video will be lost).
• To quickly format the SD CARD, turn the DVR off. Then hold the REWIND
the same time) and move the switch on the DVR to the ON POSITION. A "Format OK" message will be displayed
when the SD card is successfully formatted
3. When the SD CARD is recording video successfully, the RECORD LED will be lit.
STEALTH1
All manuals and user guides at all-guides.com
Reading SD card
and FAST FORWARD buttons (at
1
2
3
6