Table des Matières
Publicité
Hood Cleaning
Hood Cleaning
Hood Cleaning
Hood Cleaning
Hood Cleaning
Figure 8
Figure 8
Figure 8
Figure 8
Figure 8
Fig
Lights replacement
Lights replacement
Lights replacement
Lights replacement
Lights replacement
Figure 9
Figure 9
Figure 9
Figure 9
Figure 9
Figure 9
Figure 9
Figure 9
Figure 9
Figure 9
All manuals and user guides at all-guides.com
Be sure lights are cool before cleaning the hood.
To Clean Filters
To Clean Filters
To Clean Filters
To Clean Filters
To Clean Filters
• • • • • The metal grease filters will last forever.
They are made of anodized aluminum
• • • • • It is recommended that the filters be washed at least once a month; they
can be washed by hand or in the dishwasher.
• Drain water through edge holes and let each filter dry thoroughly before
replacing it.
To Remove The Metal Grease Filters
To Remove The Metal Grease Filters
To Remove The Metal Grease Filters
To Remove The Metal Grease Filters
To Remove The Metal Grease Filters
• Turn blower and lights off.
• Push each handle towards the center and pull downwards Figure 8.
To Replace The Metal Grease Filters
To Replace The Metal Grease Filters
To Replace The Metal Grease Filters
To Replace The Metal Grease Filters
To Replace The Metal Grease Filters
• Reverse procedure.
To Clean Hood Surface
To Clean Hood Surface
To Clean Hood Surface
To Clean Hood Surface
To Clean Hood Surface
• For general care, wipe the outside of the stainless steel, white, black or
glass hood with sudsy water or household cleaners such as Fantastic® or
Formula 409
marks.
• Wipe and dry brushed stainless steel in the same direction as the grain.
• Do not use abrasive products.
• To remove finger prints and give added shine use spray cleaners such as
Stainless Steel Magic
NOTE: Turn blower and lights off. Make sure the lights are cool.
Turn blower and lights off. Make sure the lights are cool. If new
Turn blower and lights off. Make sure the lights are cool.
Turn blower and lights off. Make sure the lights are cool.
Turn blower and lights off. Make sure the lights are cool.
lights do not operate be sure lights are inserted correctly before calling
service.
• Unscrew the light cover.
• Remove the damaged light and replace with a new 12 Volt, 20 Watt
(maximum) halogen light made for a G-4 base. Follow package directions
and do not touch new light with bare hands.
• Reinstall the light cover.
®
, rinse well and dry with clean soft cloth to avoid water
®
®
and Shimmer
.
9
Publicité
Table des Matières
