Troubleshooting Guide - Air King ES80S Mode D'emploi

Figure 11
2b. TWO SPEED UNITS (models ES80D and ES130D): Plug the fan's 2
pin quick connect motor cord and the 3 pin quick connect motor cord
into the receptacles located on the top of the wire compartment cover.
These cords will only fit one way into the receptacles (Figure 12).
Figure 12
3. Install the ceiling mounting flange to cover any gaps which exist
between the housing and the finished ceiling. Remove the two screws
that connect the ceiling mounting flange to the housing. Put caulk (not
provided) on each corner of the ceiling mounting flange to ensure that
the flange fits tightly against the ceiling. Line up the screw holes in the
ceiling mounting flange with the screw holes on the inside of the housing
and press flange in place so it is tight against the ceiling. Reinstall ceiling
flange mounting screws inside the housing (Figure 13).
Ceiling
Mounting
Flange
Figure 13
Trouble
1. Fan does not operate when the switch is on.
2. Fan is operating, but air moves slower than normal.
3. Fan is operating louder than normal
A210572218 Rev. i 8-12
All manuals and user guides at all-guides.com
Screws
Screw Holes

Troubleshooting Guide

Probable Cause
1a. A fuse may be blown or a circuit tripped.
1b. Connector plug from motor is not plugged in. 1b. Turn off power to unit. Remove Grill and plug motor into receptacle
1c. Wiring is not connected properly.
1d Motor has stopped operating.
2. Obstruction in the exhaust ducting.
3a. Motor is loose.
3b. Fan blade is hitting housing of unit.
www.airkinglimited.com
NOTE: If the housing is mounted to far or not far enough into the ceiling for
the flange to make a solid connection, loosen the mounting channel and
adjust the housing up or down on the rails. Once in place, fully tighten the
mounting channel nuts.
4. Install the grill by squeezing the two ends of the springs together and
installing them up into the slots on the fan's housing. Push the grill up
into position (Figure 14).
Figure 14
5. Restore power and test your installation.
SECTION 7
Use and Care
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT SERVICE
PANEL BEFORE SERVICING THE UNIT.
1. Cleaning the Grill: Remove grill and use a mild detergent, such
as dishwashing liquid, and dry with a soft cloth. NEVER USE ANY
ABRASIVE PADS OR SCOURING POWDERS. Completely dry grill
before reinstalling. Refer to instructions in Section 5 Finishing the
Installation, to reinstall grill.
2. Cleaning the Fan Assembly: Wipe all parts with a dry cloth or gently
vacuum the fan. NEVER IMMERSE ELECTRICAL PARTS IN WATER.
Suggested Remedy
1a. Replace fuse or reset circuit breaker.
in housing. Restore power to unit.
1c. Turn off power to unit. Check that all wires are connected.
1d. Replace motor.
2. Check for any obstructions in the ducting. The most common are bird
nests in the roof cap or wall cap where the fan exhausts to the outside.
3a. Turn off power to unit. Remove grill and check that all screws are fully
tightened. Restore power to unit.
3b. Call your dealer for service.
4 of 12