Dometic GROUP WAECO MagicTouch MT100 Instructions De Montage Et De Service page 36

_IA_MT100.book Seite 34 Freitag, 28. Mai 2010 9:04 21
Operating MagicTouch
Never attempt to do the following with batteries:
– recharge them,
– open them or
– throw them in fires.
To replace the batteries, proceed as follows:
➤
Use a screwdriver to open the housing.
➤
Replace the battery (1).
Make sure that the polarity is correct when you insert the battery (battery type
CR 2032 3 V). The positive terminal is at the top.
Batteries are available e. g. at photo shops, watchmakers, etc.
➤
Press both halves of the housing back together.
9.3 Learning or deprogramming the hand-held transmitter
See fig. f
MagicTouch can be operated using up to 10 hand-held transmitters. If a new hand-
held transmitter is to be learned, all other transmitters will have to be paired again.
Proceed as follows for learning a new hand-held transmitter:
To switch to learning mode:
➤
Use a hand-held transmitter to open the vehicle.
➤
Take a seat in the vehicle and leave the door open.
➤ Switch on the ignition.
➤
Press and hold the "Learn" button on a hand-held transmitter already paired.
➤
Switch the ignition off.
➤
Let go of the button.
✓
The hazard lights flash 10 times and then remain lit.
✓
The system is now in learning mode.
NOTE
I
If you do not press a button within 10 seconds, you will exit the learning
mode.
Learning the hand-held transmitter
Learn all the hand-held transmitters which you would like to use during this learning
phase. This also applies for the hand-held transmitters which you have already been
using!
➤
Press the "Learn" button on the hand-held transmitter.
✓
The hazard lights turn off while the value is being saved.
✓
If the hazard lights light up again after 2 seconds and remain lit, then the hand-
held receiver has been learned and you can now proceed with the next one.
34
MagicTouch MT100