Internal Cleaning; Cleaning Of The Toe Kick Cover And Condenser - Bertazzoni ZKS5990FZ3IU Mode D'emploi

10.2 Internal cleaning

Clean the internal and removable parts by washing
them with a solution of lukewarm water, a small
amount of dishwashing detergent.
Rinse and dry right away.
Do not use mechanical devices or other methods to
speed up defrosting.
Warning
Do not use water on the electrical parts,
lights and control panel.
Warning
The use of chlorine-based detergents or
similar that contains it should be avoided
(bleach, hypochlorite, etc).
Do not bring cold glass parts into contact with
boiling water.
Do not wash any parts of the appliance in a
dishwashing machine since this could dam-
age or irreparably deform the parts.
10.3 Cleaning of the toe kick cover, filter
and condenser.
It is recommended to perform the following cle-
aning steps very 6 months. An audio and visual
message on the display will serve as a reminder.
It is possible to disable the warning signal and see
the time left before the next cleaning has to be done.
Behind the frontal toe kick cover there is the con-
denser.
To clean it use a vacuum cleaner with a soft brush
attachment at maximum power, sweeping it along
the vent slits. In case of a significant dust build up,
the toe kick cover can be removed to allow a more
accurate cleaning of the filter.
On the mantenience settings,
installation of the unit and after it has been turned
on, you can set the condenser cleaning warning.
In the case the warning sign will be enable, there
will be an acoustic signal every 6 months, that
informs that is time to clean the condenser.
After cleaning it, touch the reset icon in order to
reactivate the warning signal in 6 months.
In the case you do not want the warning cleaning
signal of the condenser anymore, touch the off icon.
EN
Maintenance Service
after the
Info System
29