Programming The Dispenser Buttons; Preparation Of Coffee - CULUS pod1 plus Mode D'emploi

Programming the dispenser buttons

Large cup: press and hold the button
will dispense water. When the desired water quantity has
been reached, release the button
stop delivering water and will store the quantity of water to
be dispensed from now on. (Fig.8)
Small cup: Use the same procedure as for large cups. Press
and hold the corresponding button
The machine will start dispensing water. When the desired
level of water is reached, release button
will stop delivering water and will store the quantity of water
to be dispensed from now on. (Fig.8)

Preparation of coffee

• Use pods suitable for this model only.
• Place a cup under the dispenser
• Lift the control lever backwards (up to the stop point) (1)
and make sure that the pods ejection hatch (15) is open.
(Fig.9)
ATTENTION: if the hatch (15) is closed,
open it manually (Fig. 10)
• Introduce the pad properly into its seat as shown on the figure
(Fig. 11)
• Fully lower the lever (1) and press either the large cup
(D) or small cup (E) dispenser button depending on personal
(Fig. 12)
taste.
• To fully remove the pod, slowly lift the lever (1).
If the pod is not ejected, open the hatch (15) and remove it.
1
D
E
Fig. 12
(D). The machine
(D). The machine will
(E).
(E). The machine
UP
Fig. 11
10
Dispenser buttons:
9
D
E
Fig. 8
1
Fig. 9
15
Fig. 10
15