Installation - Kenwood KDC-X569 Mode D'emploi

Installation

Installation
Firewall or metal support
Screw (M4X8)
(commercially
available)
Metal mounting strap
Self-tapping screw
(commercially available)
(commercially available)
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (for example, the sound may skip).
Installing in Japanese-Made Cars
1
Refer to the section <Removing the hard rubber frame> and then
remove the hard rubber frame.
2
Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
Bend the tabs of the
mounting sleeve
with a screwdriver or
similar utensil and
attach it in place.
• During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
— 32 —
N
T
N
T/N
T
ø5mm
T: Toyota cars
N: Nissan cars Accessory3...for Nissan car
Accessory4 ...for Toyota car
8 mm
8mm
MAX.
MAX.
3
4
ø5mm