TEFAL Disney baby TD5000K0 Mode D'emploi page 39

Operation
Switching on the appliance
To switch on the appliance, press the button 4A and 4B ON/OFF on the baby unit and
the parents' unit for 2 to 3 seconds –
The ON indicators 5A and 5B will light up green on the baby unit and the parents'
fig. F
unit –
The connection indicators 6A and 6B will light up green on the baby unit and the
parents' unit: the connection is working –
If the connection between the baby unit and the parents' unit is broken (out of range,
or if the baby unit or the parents' unit is switched off), the connection indicator turns
red. On the parents' unit, you will also hear a beep (every 30 seconds) to warn you
that the connection has been broken.
It is important that you always position the parents' unit at least 1 metre from the
baby unit. When they are too close to one another, you will hear a high pitched noise.
Baby unit
Night light function
To switch on the night light, press the button 1A. To deactivate it, press the button 1A
once again.
Parents' unit
Setting the volume
You can set the volume of the parents' unit using the + and – buttons 2B. There are
6 different settings, the lowest level switches off the sound and just uses the visual
indication.
Setting the sensitivity of the microphone
The noises made by Baby may be of different levels, depending on whether crying or
murmuring in the cot. The sensitivity of the microphone allows the sound level to be
adjusted as required: the slightest noise or only if Baby is fully awake.
Press the button 7B (sensor) –
– then adjust the sensitivity by pressing the + or – buttons 2B within 3 seconds –
fig. I
. Confirm by pressing the button 7B again (sensor).
There are 5 sensitivity settings, from 1 for the lowest sensitivity to 5 for the highest
setting. T default setting is level 3.
Walkie-talkie function
To reassure Baby when he/she awakes, without having to go to the room, you can use
the walkie-talkie function.
Press the button 1B when you speak –
Noise intensity indicators
The noise intensity indicators 3B are green and red LEDs on the receiver which light
up according to the level of noise emitted by the transmitter. There are 8 noise levels,
from the lowest to the highest:
– Level 0: 0 green light, no sound emitted
– level 1: 1 green light lit
fig. E
fig. F
fig. G
– until the indicator number 4 lights up –
fig. J
, then release it to listen to Baby again.
FR
NL
DE
IT
ES
PT
EN
EL
TR
RU
UK
PL
CS
SK
HU
BG
RO
fig. H
HR
KZ
39