Audio Playback - Loewe Audiodesign Speaker 2go Mode D'emploi

Speaker 2go
Operating instructions

Audio playback

Audio playback
The Speaker 2go must be linked via Bluetooth (page 24) or Connectivity
Easy Pairing (page 25) or connected via audio cable (page 23) to your
audio source and turned on (page 22).
For playback, the following sequence applies: Handsfree operation prior to
Bluetooth audio playback prior to wired playback. This means that playback
of audio content via the audio cable is only possible when audio content is
neither played back from a device linked via Bluetooth nor via the integrated
handsfree equipment.
Start the audio playback on your audio source.
When using an audio cable connection (page 23) adjust the volume of your
audio source to a high level and select the desired volume on the Speaker
2go to avoid interfering noise.
Adjust the volume on the Speaker 2go with the +/- keys
be adjusted in 24 steps which are represented visually by six LEDs of the LED
indicator
Pressing briefly the +/- key
When keeping the + or - key pressed you traverse the whole volume range.
The maximum volume is indicated by two flashes of all six LEDs with full
brightness.
Loud music can lead to ear damage. Avoid extreme volume especially over
long periods.
Mute the Speaker 2go by pressing the + and - keys
LEDs of the LED indicator
are dimmed. By pressing the + or - key
indicator shows the original volume again.
8 (volume).
7 increases or decreases the volume by one step.
(volume) flash with full brightness, all other LEDs
8
- 26 -
7 . The volume can
7 simultaneously. All six
7 the muting is cancelled. The LED