Bluetooth Link; Linking The Audio Source Via Bluetooth - Loewe Audiodesign Speaker 2go Mode D'emploi

Speaker 2go
Operating instructions

Bluetooth link

Linking the audio source via Bluetooth

You can link your Speaker 2go to an audio source, e.g. smartphone, tablet PC, etc. using a
wireless Bluetooth connection. The audio sources must support the Bluetooth A2DP protocol.
The distance between your Speaker 2go and the audio source must be no more than 10m
(line of sight).
Up to 5 audio sources can be memorized by the Speaker 2go via Bluetooth. However, only
one active connection is possible at a time.
Press the key
You hear a signal tone. The LED indicator
Enable the Bluetooth function of your audio source. If necessary, get help
from the instruction manual of your audio source.
If necessary, confirm the Bluetooth Search function of the audio source.
Now, Bluetooth devices will be searched near the audio source.
Select Speaker 2go.
If a code is requested, enter 0000.
After the linking is completed you hear a signal tone. The LED indicator
up permanently; the Speaker 2go is now ready for audio playback (page 26).
For some audio sources, the link must be explicitly enabled before music
playback can be heard from the Speaker 2go.
When switching the speaker 2go to standby using the
will be delinked.
After switching the Speaker 2go on again using the
tries to link to the audio source. In this situation the LED (Bluetooth)
After successful linking the LED
3 on the Speaker 2go for a long period (approx. 3 sec).
4 will light up permanently.
- 24 -
4 (Bluetooth) will flash.
3
1 key, the audio source
1 key, the Speaker 2go
4
4 lights
pulses.
4