PROPOINT 8381634 Mode D'emploi page 7

V2.0
MAINTENANCE
Before making any adjustments or changing any accessory, turn off the tool and unplug it from its
air source.
1. Although the sander does not require user maintenance, the sander should be kept clean.
Wipe the sander with a clean cloth and periodically blow out all areas with compressed air
or use a brush. Do not use harsh chemicals or solvents to clean the sander. These chemicals
could seriously damage the plastic housing.
2. Avoid overloading the sander. Overloading will result in considerable reduction of speed and
efficiency and the unit will become hot. In this event, run the sander at a "no load" condition
for a minute or two.
3. Regularly inspect all mountings and screws to ensure tightness. Should any screws become
loose, tighten immediately.
4. If repair is required, take the sander to an authorized service center.
5. Check for damaged parts. Before using any tool, any part that appears to be damaged
should be carefully checked to determine that it will operate properly and perform its
intended functions. Check for alignment and binding of moving parts, for broken parts or
mounting fixtures, or for any other condition that may affect proper operation. Any part that
is damaged should be repaired or replaced by a qualified technician.
6. When servicing, use only identical replacement parts. Only use accessories intended for use
with this tool. Replace damaged parts immediately.
7. Keep the tool clean. Wipe the tool with a clean cloth and periodically blow out all areas with
compressed air. If compressed air is not available, use a brush to remove dust from all areas.
Do not use harsh chemicals or solvents to clean the tool. These chemicals could seriously
damage the plastic housing.
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate
recycling facility.
For technical questions call: 1-800-665-8685
AIR BELT SANDER 8381634
7