Preparing For First Use - brondell Halo PH10-B Manuel De L'utilisateur

PREPARING FOR FIRST USE

Be sure to remove all plastic packaging from the filters before turning the Halo on.
1. Remove the Front Panel by pulling the bottom of the panel
away from the unit and pushing upwards until the panel
comes off.
2. Press the two tabs on the Mesh Pre-Filter down and pull
the filter straight out of the Filter Cabinet. Remove the
Carbon Filter from the back side of the Mesh Pre-Filter.
Pull out the True HEPA Filter by the white fabric tab at the
top of the filter.
3. Remove all plastic packaging from the filters.
4. Put the filters back into the unit in the following order:
True HEPA Filter (this goes in first)
Carbon Filter
Mesh Pre-Filter
NOTE: Make sure that the white tab labeled "FRONT"
on the True HEPA is facing towards the front of
the Halo.
5. Re-attach the Front Panel by inserting the tabs on the top
of the Front Panel into the slots in the top of the unit's
body. Then, push the bottom of the panel towards the unit
until the Front Panel is securely in place.
Step 1
Step 2
Step 5
7