ECOHOUZING NT15-13C Manuel D'instructions page 6

TROUBLE SHOOTING
Problem
The heater does not operate.
The heater shuts off and the
temperature setting light flashes.
The heater shuts off.
The alarm sounds and the
LED lights flash.
The room is not hot enough.
We recommend that the heater be cleaned at least once a month and before storage.
● Turn the heater off and unplug it. Allow it to cool before handling and storing.
● Use a dry cloth to clean the external surfaces of the heater.
DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION.
● Clean your heater by the above-mentioned steps, then pack the heater in its
original container and store it in a cool, dry place.
● This heater should not be disassembled.
● Under normal use and circumstances, the motor is factory lubricated and will
require no further lubrication.
SPECIFICATIONS
Voltage Frequency
120 V AC 60 Hz
All manuals and user guides at all-guides.com
Reason
There is no power.
The set temperature is lower than
the current room temperature.
The room temperature has reached
the temperature set at the thermostat.
One of the safety protection devices
had been activated to prevent
overheating.
1. The room is too large.
2. The window is open.
1. The set temperature is too low.
2. The heater was operating at the low
power setting (900W)
Wattage Max. Current
1500 W
Be sure it is plugged in and that the electrical outlet is working.
Set the desired temperature higher than the current temperature
to restart the heater.
1. This is normal situation. The heater will restart to work once
room temperature is lower than set temperature.
2. Adjust the thermostat setting if it's not set to your desired
temperature.
temperature.
1. Place the heater in the upright position.
2. Check for obstructions. If you find an obstruction, turn the
heater off.
3. Unplug the heater and wait at least 10 minutes for it to cool
down.
4. Carefully remove the obstruction. Plug the heater in and
restart it as described in the OPERATION section.
5. If you still notice the same problem, remove the plug from the
outlet and have the appliance checked by an authorized service
person
1. Turn on the main heat source of the room.
2. Use more portable heaters.
3. Close the window.
Select the high power setting (1500W).
Increase the temperature setting or select the "Max" mode (
BTU Output
12.5 A 5120
6
Solution
Coverage Area
(Reference only)
160 sq. ft. (15 m
).
)
2