Control Panel; Setting The Power; Setting The Temperature - ECOHOUZING NT15-13C Manuel D'instructions

enough to burn exposed skin. Use of this heater is not recommended for persons
with reduced sensitivity to heat or an inability to react to avoid burns.
19. When switching on the heater for the first time, allow it to run at full power for
about two hours to get rid of the unpleasant smell.
20. This heater is for household use only.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot,
fully insert.
SAVE THESE INSTRUCTIONS.
OPERATION
● Place the heater on a firm, level surface free from obstructions, and at least
3' (0.9 m) away from any wall and any other objects such as furniture, curtains,
plants or combustible material.
● Plug the unit into a grounded 120 V AC household outlet in perfect working
condition.

Control Panel

● SETTING THE POWER
When the power key
and temperature setting at 30˚C. Press this key repeatedly to select desired operating
modesin a circular sequence HIGH (
: The fan and heating elements operate at 900 W.
: The fan and heating elements operate at 1500 W.
● SETTING THE TEMPERATURE
When the heater is working, press the UP key (
desired temperature between 18˚C to 30˚C in increments of 3˚C. The unit will select
the operating mode based on the following two conditions:
a. If the set temperature is higher than the room temperature, the heater will
continue to heat until the room temperature reaches the set temperature.
Once the room temperature reaches the set temperature, the heating element will
stop heating and the temperature setting LED lamp will flash. The heater will
resume heating when the room temperature falls below the set temperature. The
heater will switch on and off to maintain the set temperature.
b. If the set temperature is lower than or equal to the room temperature, the
temperature setting lamp will flash, and the unit will stop heating.When the room
temperature falls below the set temperature, the unit will resume heating. The
heater will switch on and off to maintain the set temperature.
All manuals and user guides at all-guides.com
1 2 4 8
18ºC 21ºC 24ºC 27ºC 30ºC
is first pressed, the unit will run at high power setting (
A. Timer Setting Display Area
B. Temperature Setting Display Area
C. Power Setting Display Area
D. Function Control Key
) -LOW ( ) -STANDBY.
) and DOWN key (
3
)
) to set the