Setting The Timer; Using The Remote - ECOHOUZING NT15-13C Manuel D'instructions

OPERATION
"Max" mode (
oncemore to select the "max" mode (
disabledand the heater will continuously heat at the current selected power setting.
Note: Every time the heater is switched on, it will heat at the high temperature setting
for two minutes. After that, the heater will operate according to the instructions above.
Any time the heating elements are shut off, the fan motor will continue to run for
about 15 seconds before shutting off. This is a safety feature that is designed to
protect the
● SETTING THE TIMER
When the heater is on, it can be set to turn off automatically in one to 15 hours by
hourly increments.a. There are four timer settings on the panel "1," "2," "4," "8." By
pressing the timer setting key (
15 hours maximum by combination of "1," "2," "4," "8." The combination of LED
ligths will change to indicate the remaining time before the unit turns off. For
example, when 11 hours is selected, the LED lights under figures"1," "2," and "8"
will light up because those numbers add up to 11.
After five hours, the LED lights under figures "1" and "8" will be extinguished and the lights
under figures "2" and "4" will light up instead because those numbers add up to six,
indicating that the unit will automatically turn off in six hours.
b. To cancel the timer, press the timer key (
"2," "4," and "8" are extinguished.
● SETTING THE OSCILLATION
The heater will oscillate by pressing the oscillation key (
press this key again. This key only works when the heater is working.
OPERATION
● USING THE REMOTE
All manuals and user guides at all-guides.com
): When the set temperature at 30˚C, press the UP key (
1 2
1 2
), the temperature setting function will be
) repeatedly, the heater can be set to turn off in
4 8
4 8
) repeatedly until all the lights under "1,"
4
) once. To stop the oscillation,
)