Koenic KHS 402 P Mode D'emploi page 16

English
Operation
Connecting to power: Connect the power
1
plug to a suitable electrical outlet.
Unlocking appliance: Push the lock
2
switch to the power cord side.
Switching appliance on: Press the on/off
3
button for 2 seconds.
The ceramic plates start to heat up and the
default temperature of 140 °C appears on
the display for a moment.
Adjust the ceramic plates' temperature
4
between 140 °C and 220 °C in increments
of 10 °C by pressing the temperature
buttons:
Button Temperature
+ increase temperature
(max. 220 °C)
–
decrease temperature
(min. 140 °C)
The current temperature setting is shown
on the display, as the temperature buttons
are pressed.
Note
The appliances switches itself off after
30 minutes if it has not been switched off
manually already
Switching appliance off: Press the
5
on/off button for 2 seconds. The display
goes off.
16
IM_KHS 402P_150409_V01.indb 16
All manuals and user guides at all-guides.com
After use: Unplug the appliance and place
6
it on a heat-resistant surface to let it cool.
Locking appliance (button lock): Push
the lock switch to the display side.
Straightening
Caution
Make sure your hairs are completely dry
before using the appliance.
7 Comb your hairs through with a wide
toothed comb (not provided) to remove
tangles.
Starting close to the roots, take a thin
8
section of hairs (strands of max. 3 – 4 cm)
and clamp.
Danger of burns! Parts of the appliance
become very hot during use. Hold the
appliance by its handle only.
Note
During operation, the built-in ioniser makes
your hair shinny and frizz-free.
Gently run the appliance through the entire
9
length of the hairs, slowly and steadily,
from roots to the ends without stopping
for longer than 4 to 5 seconds. This will
ensure best straightening results without
damaging your hairs.
Creating flicks
You can create flicks at the hair ends
10
by slowly turning the appliance either
outwards or inwards before releasing a
strand.
E
9/4/15 4:55 pm