Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Sharpen in a forward motion a few times and repeat this
on all the cutting edges facing the same way (right or left).
• To move the chain forward, use a screwdriver.
• Turn the bar over in the vise and repeat on all the other
cutting edges.
• Check that the depth limiter tooth does not stick out
farther than the inspection tool and file any projecting
parts with a flat file, rounding off the edges (Fig. 24).
• After sharpening, remove all traces of filing and dust
and lubricate the chain in an oil bath. Replace the
chain whenever:
– The length of the cutting edges decreases to 5 mm
or less;
– There is too much play between the links and the rivets.
Guide Bar Maintenance
When the guide bar shows signs of wear, turn it over on the
saw to distribute the wear for maximum bar life. Feathering or
burring of the bar rails is a normal process of bar wear. You
should smooth such faults with a file as soon as they occur.
Replace a bar with any of the following faults:
• wear inside the bar rails permitting the chain to
lay over sideways
• bent guide bar
• cracked or broken rails
• spread rails
Turn the saw over, check the underside of the guide bar, and
make sure that the lubrication holes and chain groove are free
from impurities.
You can purchase replacement parts for your Sun Joe
24V-10CS cordless chain saw by ordering online at
sunjoe.com or, to order by phone, contact
Snow Joe
+ Sun Joe
customer service at
®
®
1-866-SNOWJOE (1-866-766-9563).
Chain Sprocket
Regularly check the condition of the sprocket and replace it
when wear exceeds 0.5 mm (Fig. 25).
Fig. 25
Do not mount a new chain with a worn sprocket or vice-versa.
®
< 0.5 mm
Troubleshooting
Troubleshooting Tips
Most difficulties are easy to fix. Consult the troubleshooting
table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor
adjustments, please call 1-866-SNOWJOE (1-866-766-9563)
for assistance.
m
WARNING!
Always remove the battery before
performing any adjustments, maintenance, or repairs to your
cordless chain saw.
Troubleshooting Table
Problems
Corrective Action
The saw
•
Make sure that the battery is inserted correctly
motor fails
•
Check charge status and recharge the battery
to start
•
Make sure that the battery is inserted correctly
The saw
•
Check charge status and recharge the battery
stops during
•
The machine is overloaded
operation
•
The front hand brake is engaged
The saw
runs, but
the chain
•
The chain is too tight; re-tension.
speed is
low
Bar and
•
The chain tension is too tight; re-tension.
chain
running
•
The chain oil tank is empty; refill.
hot and
•
The lubrication holes are plugged; clean them out.
smoking
The saw
motor
•
The chain tension is too tight; re-tension.
runs, but
•
The guide bar or chain is damaged; inspect
the chain
and replace the damaged part.
is not
turning
19
Publicité
Table des Matières
Dépannage
