Klarfit Gym 5000 Mode D'emploi page 38

Step 3
Attach Vertical support (5) to Main
base tube (1) using Hex bolts
M10x50 (74 - 2 sets), washers and
nuts.
Step 4
l.Attach Upper support (4) to Ver-
tical support (5) using reinforced
plate (48) and Hex bolts M10x50
(74 - 2 sets) and insert chrome bars
(22) into holes of upper support (4)
using Hex bolts M10x20 (78 - 2
sets).
Attach seat support (6), reinforced
tube (8) to Vertical support (5) using
reinforced plate (48) and Hex bolts
M10x50 (74 - 2sets), bolts M10x45
(75 - 1 set) washers and nuts.
Attach vertical tube (59) to back
base tube (2) using reinforced plate
(48) and Hex bolts M10x50 (74 - 2
sets), washers and nuts.
Step 5
Attach T shaped support bar (13)
and pulley shaft (51) to Vertical
support using Hex bolts M10x50
(74), washer and nut.
Attach Chest press (10) to Up-
per support (4) using Hex bolts
M12x145 (67), steel bushing (42),
washer and nut.
Attach pulley seat (32) to pulley
shaft (51) using Hex bolts M10x60
(73), washer and nut.
Attach T shaped bolt (31) to T
shaped support bar (13) using Hex
bolts M10x60 (76), washer and nut.
38