Important Safety Instructions; Special Instructions - Voltage Valet HS2 Manuel D'instructions

IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be followed,
including the following:
Read all instructions before using
DANGER, KEEP AWAY FROM
WATER
—As with most electrical appli-
ances, electrical parts are electrically live
even when the switch is off.
TO REDUCE RISK OF ELECTROCUTION:
1. Always unplug this appliance immediate-
ly after using. Never pull on the power
10. The hair straightener plates are hot when
in use. Do not let eyes and bare skin
touch heated surfaces.
11. Do not place the hair straightener direct-
ly on any flammable surface while it is
hot or plugged in. Place ONLY on a flat
heat-resistant surface.
12. Do not use an extension cord with this
appliance.
SAVE THESE
INSTRUCTIONS
WARNING
—This appliance heats to an
extremely high temperature and the follow-
ing will safeguard you from the straight-
ener being used incorrectly.
cord. Hold the power plug when remov-
ing it from the socket.
2. Do not use while bathing.
3. Do not use, place or store this appliance
where it can fall or be pulled into a tub
or sink.
4. Do not place in or drop into water or
other liquid.
5. Do not reach for an appliance that has
fallen into water. Unplug immediately.
WARNING
—To reduce the risk of burns,
electrocution, fire or injury to persons:
1. An appliance should never be left unat-
tended when plugged in.
2. Close supervision is necessary when this
appliance is used by, on or near children
or individuals with certain disabilities.
3. Use this appliance only for its intended

SPECIAL INSTRUCTIONS

To avoid a circuit overload, do not operate
another high wattage appliance such as
a hair dryer, etc., at the same time on the
same circuit.
This appliance has an automatic cut off
switch that shuts the straightener off
should it overheat.
If any fault occurs do not attempt to repair
it by yourself. This appliance has no user-
serviceable parts.
OPERATING INSTRUCTIONS
1. Plug the appliance into a 100, 120 or
240 VAC electrical outlet. NOTE: This
appliance automatically operates from
100 to 240 VAC which eliminates the
need for a voltage selection switch.
use as described in this manual. Do not
use attachments not recommended by
the manufacturer.
4. Never operate this appliance if it has a
damaged cord or plug; if it is not work-
ing properly; or if it has been dropped,
damaged or dropped into water.
5. Keep the cord away from all heated sur-
faces. Do not wrap the cord around the
appliance.
6. Never place the appliance on a soft sur-
face, such as a bed or couch. Keep free
of lint, hair, etc.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening.
9. Do not use outdoors or operate where
aerosol (spray) products are being used
or where oxygen is being administered.
A Voltage Valet adaptor plug may be
required to modify the appliance plug to
fit 240 VAC foreign electrical outlets.
2. Move the ON/OFF switch to the ON posi-
tion. A steady Red light appears near
the ON/OFF switch when the plates are
heating. The Red light blinks when the
desired temperature is reached.
3. Adjust the temperature dial from Low
to High according to hair texture (lower
temperatures for thin hair, higher tem-
peratures for thick hair).
Low temperature approx. 170° F
High temperature approx. 400° F
4. After approximately 30 seconds the
appliance is ready to use. The Red light
will start blinking.
5. Proceed with hair styling. Do not jerk,
twist or strain the power cord during use.