auna multimedia Tower 70 Mode D'emploi page 18

PLEASE NOTE:
You should now be able to place the speakers freely from room to room without disruption. If disruption
should occur (signal breaks up), press the "TUNE" button under the speakers to maximize best reception.
If you hear interference from other components, switch the channel control of transmitter, and then move
the speakers to other free location. You can re-adjust the tuning control by moving it among channels of
the transmitter, then pressing "TUNE" button of the speakers for best reception.
When transmitting / receiving over long distances, the signal from the system will become weaker.
NO SOUND
• Ensure the AC adaptor is fully inserted into the AC outlet and the power connection input on the
transmitter.
• Ensure the speaker is switch ON.
• Speaker's battery capacity is too low, replace with new batteries or connect the AC adaptors to the
speakers.
• Ensure the TV or audio component is ON.
• The connected audio / video equipment is not playing. Start playing the equipment.
• The volume of speaker is too low, adjust the volume to an appropriate level.
DISTORTED SOUND
• Press the "TUNE" button under the speakers until the frequency between the transmitter and speakers
are matched.
• Change the position of the channel selector on the transmitter. You must then press the "TUNE" button
on the speakers.
• Battery capacity is too low. Replace with the new battery.
• Ensure the volume level of speakers is adjusted properly.
• The speaker is too far away from transmitter, move them closer.
• The input level of the audio signal is too low. Turn up the volume of the audio source equipment.
18
Troubleshooting