Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Turn on the audio source to which the transmitter is connected with. The Signal LED on transmitter
will light up.
•
Select a channel of the transmitter for best performance in your location.
•
Select the L/M/R (Left/Mono/Right) selector under the speakers, one to L (Left) and the other to R
(Right) for the best stereo reception. In case the audio device only provides Mono audio signal, select
to M (Mono) for the best mono reception.
•
Press the "POWER" button on the speaker to turn on the speaker. Press the "TUNE" button to get the
best tuning reception in the speakers. When the button is pressed, frequency tuning starts automati-
cally and it stops when a signal is detected.
•
Volume can be adjusted on the speakers by pressing the up or down buttons or by pressing " + " or
" – " on the remote control.
•
Tuning:
•
Keep a distance of 7 meters between speaker and transmitter, and then press TUNE for best
reception.
•
Once the frequency is jammed, select another channel on the transmitter, then press TUNE again.
•
Switching Off:
•
For protection of the transmitter and power saving, the transmitter will cut off automatically if
there is no/weak operation input signal from audio source for 4 minutes. In other words, if the
signal comes back, the transmitter will work again automatically.
•
Press POWER to turn off the speaker and the LED light goes off.
Operation
17
Publicité
Table des Matières
